iPhone iPad battery genuine fake Identification Efficiency Tester with battery test board
Apple Battery Health Battery Life Capacity Cycle Count Diagnostic Tester for iPhone iPad Battery genuine and fake identification test, check Apple battery life, battery efficiency, capacity, data clearance, discharge rate, cycle count...
PDF user manual :
- Battery performance diagnosis, identifying the original battery and cottage
- Battery cycles
- The battery design capacity
- The battery full charge capacity
- The battery voltage
- The temperature of the battery
- Quiescent current of the battery
- Battery protection board chip IC model
- Battery charge activation, charge-discharge function
- The battery discharge current, charge-discharge graph
- Automatically identify the original iPhone cable (in future, not added)
- Apple battery cycles is cleared
- Battery chip detection, repair battery serial number and factory information
Supporting Models :
- iPhone 4 4S 5 5C 5S 5SE 6 6P 6S 6SP 7 7P 8 8P X
- iPad Mini 1 2 3 4
- iPad 3 4
- iPad 9.7 (New)
- iPad Air 1, Air 2
- iWatch 1: 38mm, 42mm
- Watch 2: 38mm, 42mm
Writing the cycle times at random :
Double-click the button on the right to write randomly the cycles times of battery (1-9).
The times of battery cycles is cleared :
Click the right button, then, the times of battery cycles is cleared.
Battery charging activation :
The box needs to be connected to the charger, plug in the battery, short press the left button, it will enter the charging state, at this time, the battery current will display the charging milliamps, the default is maximum 500ma;
This function is for batteries which can not charge and need to be charged.
Special Reminder :
Regarding the problems that occurred during the upgrade process, if upgrade is successful but the instrument does not restart automatically, you need manually turn the power off and turn it on again.
If upgrade is unexpectedly interrupted or failed, you can turn off the power, then press the right button on the instrument and turn on the instrument again. Computer will prompt the instrument has been connected, upgrade mode, and now, you can upgrade again.
The instrument itself needs to be fully charged and used so that get an accurate test result. If the power supply is insufficient, please charge it in time. The upper right corner on the screen is the battery power of the instrument. If the screen dim out or flickering during the test, it is considered as low power. Please charge and use it
Common problems :
1: Can this instrument repair a bad battery?
This test instrument cannot repair cells which is caused by physical damage due to the service life! It only can detect the performance and various parameters of battery, The function of repairing the battery efficiency is only for customers who need it (Such as: the battery, having a small problem, need to return to the factory to repair and re-sell). After repairing, it will back to the original efficiency after several times of automatic charging and discharging.
2. Original 1:1 is genuine
If the original 1:1 appears, it means that it is the high imitation battery, or the data inside the original battery has been modified (some are capacity, some are factory code, etc.), also some are the developed battery board with the TI chip program.
3. Battery voltage low alarm
When the voltage output of battery output interface is lower than 3V, it still says low voltage after charging. Then maybe the battery interface is bad, or the contact is not good, or the battery cable is broken, or the battery itself is broken.